Overview
As embedded boards move to smaller, faster application processors, the parallel RGB interface that older display modules relied on has become a bottleneck – too many pins, too much EMI, and not enough bandwidth for higher resolutions. MIPI-DSI solves that by driving the panel over a small number of differential lanes, which is why most current single-board computers, industrial handhelds, and smart terminals now expect a display with a MIPI interface rather than a parallel one.
This category covers TFT modules built around a MIPI-DSI receiver, ranging from small 2.4 inch panels for handheld instruments up to 10.1 inch modules for HMI and gateway devices. Each module pairs the glass cell with a driver IC and a flex cable connector matched to common embedded processor families, so the display can be brought up with a standard Linux or RTOS display driver rather than a fully custom timing controller design.
Because these modules are meant to be designed into a product rather than swapped out later, the panels grouped here are also documented with clear timing parameters, connector pinouts, and initialization sequences to shorten the board bring-up process.
English
Español
